+- PLE forum (https://www.forum.ple4win.nl)
+-- Forum: Support (https://www.forum.ple4win.nl/forum-5.html)
+--- Forum: PLE User Interface (https://www.forum.ple4win.nl/forum-29.html)
+--- Thread: Ple4Win isn't always updating the PIPEDIM output table after testing (/thread-37.html)
Ple4Win isn't always updating the PIPEDIM output table after testing - shaswin - 01-11-2009
Bug was detected in Ple4Win version 4.0.11. I don't know if this still exists in version 4.1.1.
These were the steps I did:
- Convert a PLE3 project file to Ple4Win;
- Open project File in Ple4Win, set back function 3;
- Change a value, for example a wall thickness for one or more idents;
- Check the table and run this function;
- Check the PIPEDIM output table. The values here weren't changed, it still used the old wall thickness.
This inconsistency could not always be reproduced.
RE: Ple4Win isn't always updating the PIPEDIM output table after testing - Dr. J Foerster - 02-11-2009
Hello,
We never (yet) had a situation in which after testing an input table and executing the design function output data showed "old" data. So we will certainly look into this...
Jens Foerster
RE: Ple4Win isn't always updating the PIPEDIM output table after testing - shaswin - 02-11-2009
If this problem will occur again I will send the project file. This happened only once.