+- PLE forum (https://www.forum.ple4win.nl)
+-- Forum: Support (https://www.forum.ple4win.nl/forum-5.html)
+--- Forum: PLE User Interface (https://www.forum.ple4win.nl/forum-29.html)
+---- Forum: Suggestions and Feedback (https://www.forum.ple4win.nl/forum-10.html)
+----- Forum: Wish List (https://www.forum.ple4win.nl/forum-21.html)
+----- Thread: Multi-Graphs evolving (/thread-393.html)
Multi-Graphs evolving - Faycal - 27-06-2013
When in pipe data (function 3.1) it is possible to declare different (an)isotropic materials along with each an according yield strength.
If in a pipeline different materials are used which is often the case when installing a new pipeline, there is a limitation in strength for each material.
Wish: to be able to enter different Y-references for a certain X-interval.
The easiest way to do this, is to add the white color to the set of colours that are already present in the program.
P.S. When a section of the pipeline falls under NEN 3651, the stresses and deformations are also multiplied by a certain safety factor. An other Y-reference applies for this section too.
To show what I am aiming for, I have added two images to this thread. I adjusted one of these images, so now it shows that no calculated stresses exceed the allowed stress according to NEN 3650.
RE: Multi-Graphs evolving - Dr. J Foerster - 05-07-2013
We will take your idea into consideration. I am not quite sure I understand what the use of a white colour is though.
Most likely we will add a feature allowing the user to add a user-defined curve to the MultiGraph. This allows for greater flexibility and is more user-friendly than adding even more columns to the curve setup grid.
This request has been assigned ticket J-393.