This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
PLE forum › Pipeline strength and stability analysis › General Technical Matters
SWEIGHT factor for PE pipe

Thread Closed 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
SWEIGHT factor for PE pipe
05-04-2013, 04:36 PM,
#2
ir. M. Lammers Offline
Moderator
*****
 		Posts: 4
Threads: 0
Joined: Aug 2009
Reputation: 0
RE: SWEIGHT factor for PE pipe
Factor 0.65 should be used in the following columns: SXUB1, SXUBH, SXIOSH, SFIOSH, SXIORA and SFIORA.
Factor 1 should be used in the following columns: SXUB0, SFUBA and SFURA.

Marco Lammers.
Find
Thread Closed 


Messages In This Thread
SWEIGHT factor for PE pipe - by peipei - 26-06-2012, 03:17 PM
RE: SWEIGHT factor for PE pipe - by ir. M. Lammers - 05-04-2013, 04:36 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)