This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
PLE forum › Support › General Support & Troubleshooting
implosion

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
implosion
14-03-2012, 06:34 PM,
#1
peipei Offline
Junior Member
**
 		Posts: 17
Threads: 14
Joined: Dec 2011
Reputation: 0
implosion
Hallo,

where could I find the initial ovalisation of the pipe, which is in the chapter D.3.3.4.1 of NEN3650-2?

Is there an output table for that parameter?

Thanks.
Find
Reply


Messages In This Thread
implosion - by peipei - 14-03-2012, 06:34 PM
RE: implosion - by ir KW Radder - 10-05-2016, 03:51 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)