This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
PLE forum › Support › PLE User Interface v
Q module shouldn't be active in NEN Analysis Mode

Thread Closed 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Q module shouldn't be active in NEN Analysis Mode
20-06-2012, 01:08 PM, (This post was last modified: 20-06-2012, 01:09 PM by shaswin.)
#1
shaswin Away
Alias
***
 		Posts: 217
Threads: 113
Joined: Dec 2008
Reputation: 0
Q module shouldn't be active in NEN Analysis Mode
Version: Ple4Win v4.2.0
Reproducible: Always

When you are doing a NEN 3650 Analysis calculation and you have a BENDPAR < 0.10 you will get this error:

[attachment=348]

When you hit the "Stop Execution" button the Model Options in DF1 for the Q-Module will be available in NEN 3650 Analysis Type, see printscreen below. This shouldn't be possible.

[attachment=349]

You can't do this calculation, see this message:

[attachment=350]
Find
Thread Closed 


Messages In This Thread
Q module shouldn't be active in NEN Analysis Mode - by shaswin - 20-06-2012, 01:08 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)