This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Bug of bend component
28-08-2012, 02:29 PM,
#2
RE: Bug of bend component
Hi peipei,

I checked your issue with a colleague. The Radius is set to 0 in SHAPEP because the calculated bend length becomes less then 0.2 times the specified bend element length (in POLYDIF). In your case the bend length is approximately 8 [mm] whilst the specified bend element length is 50 [mm].

If I am correct you should have got warning W200/4: "Zero bend angle with radius". Unfortunately this is not a very proper warning for this situation since the bend angle is not near zero, but the calculated element length is too small. The warning will be either adapted or a new warning will be added to notify the user that the Radius is set to 0 due to a bend length less then 0.2 times the specified bend element length. This issue is noted as ticket J-335.


Messages In This Thread
Bug of bend component - by peipei - 28-08-2012, 11:51 AM
RE: Bug of bend component - by P Herwig MSc - 28-08-2012, 02:29 PM
RE: Bug of bend component - by peipei - 28-08-2012, 03:06 PM
RE: Bug of bend component - by P Herwig MSc - 28-08-2012, 05:22 PM
RE: Bug of bend component - by P Herwig MSc - 09-05-2016, 12:49 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)