Ple4Win isn't always updating the PIPEDIM output table after testing

[shaswin]

Bug was detected in Ple4Win version 4.0.11. I don't know if this still exists in version 4.1.1.

These were the steps I did:

- Convert a PLE3 project file to Ple4Win;
- Open project File in Ple4Win, set back function 3;
- Change a value, for example a wall thickness for one or more idents;
- Check the table and run this function;
- Check the PIPEDIM output table. The values here weren't changed, it still used the old wall thickness.

This inconsistency could not always be reproduced.

[Dr. J Foerster]

Hello,

We never (yet) had a situation in which after testing an input table and executing the design function output data showed "old" data. So we will certainly look into this...

Jens Foerster

[shaswin]

If this problem will occur again I will send the project file. This happened only once.